Electrical Inspector
CEG International
مجموع سنوات الخبرة :23 years, 8 أشهر
• Assists and coordinate with the resident or senior electrical engineer for the management and supervision of electrical aspects of the project.
• Responsible in preparing and maintaining site diaries on daily basis at site and maintain a good understanding of the project priorities and programs.
• Records all significant events and relevant issue affecting the process of the works and coordinate with senior electrical engineer responsible.
• Assures incoming quality of received materials and confirm the approved material submittals.
• Carry-out regular site inspection for all electrical permanent works for specifications and drawing compliance and maintain records of inspection requests and other work related documents at site at all times.
• Responsible for the accuracy of the work for electrical transmission distribution substation, primary protection of lighting and power, fire alarm and voice evacuation paging system and public address system, telephone/data system, emergency lighting system, structured cabling, earthing and lightning protection system.
• Witness the testing and commissioning of the equipment installed and record results/data during the testing and commissioning then report directly to the senior electrical engineer.
• Review electrical plans for the pre and post contract stage, study carefully all tender documents such as drawings, specifications and bill of quantities.
• Review plans for other services with electrical works for possible conflicts during the installation and recommend ways and means to resolve the same.
• Prepare cost estimates for electrical materials and schedule the scope of electrical works.
• Review materials submittals and note down comments prior to forwarding the same to the head of electrical designer for approval.
• Prepare quantity take-off based on tender drawings and make draft comparison sheets report showing the variances between the drawings, bill of quantities, specifications and coordinate with the consultant.
• Prepare request for information if some discrepancies are found in the drawings which are not clear and needs some more information.
• Prepare and submit reports to the estimate section manager regarding any noted discrepancies.
• Prepare electrical bill of quantities showing the required quantities based on the shop drawings and handed to electrical Quantity Surveyor.
• Report directly to the managers.
• Conduct daily inspection on quality works installed, making sure all works done were in accordance with the plan and specifications.
• Supervise, check and monitor the electrical works implemented by the administration to ensure the materials used are in accordance with the plan and specifications.
• Coordinate works with the relevant discipline to ensure the compatibility throughout the construction.
• Ensure that the works procedures are followed and that the quality standard is achieved.
• Witness the testing and commissioning conducted by the contractor and records observation results/data during the testing and commissioning.
• Report directly to the manager.
• Supervise foremen, electricians and contractor’s electrical works to ensure the works are in accordance of the construction drawings and specifications. \n \n• Determine and request the material use at site for each designated project and request to the warehouse then brought to the site for then to install. \n \n• Supervise, check and monitor the electrical works implemented by the administration to ensure the material used is in accordance with the plan and specifications. \n• Monitored electrical installation such as lighting, power, telephone, computer and fire alarm system, panel distribution board installation and all electrical works as per drawing and specification. \n \n• Ensure that the work procedures are followed and that quality standard is achieved. \n \n• Coordinate works with the relevant discipline to ensure the compatibility throughout the construction. \n \n• Witness the conducted insulation and continuity test of wires and cables installed. \n \n• Witness the testing and commissioning conducted by the contractor and record the observation results/data during the testing and commissioning. \n \n• Report directly to the manager.
Graduated as a non-academic scholar.