electrical technician
Cement Products Industry
Total des années d'expérience :8 years, 6 Mois
Carry out maintenance the machines products and reprogramming the
machines by using the manual book.
making troubleshooting and repair for the electromechanical
carry out maintenance the electricity inside the industrial
make plan with the team and co‑workers
building the machines and making also wiring for the cables inside the
panels and make a way for the cable tray in the machines
carry out maintenance the air compressor in every week and check the
cables from the heat that caused by the heat that came out of the air
compressor.
Carry out maintenance the Panels in the LV Room inside the buildings and
repair all the sensitive electromechanical inside the panels.
there is a schedule for checking the cables and the panels also the
component every 2 weak called preventive plan maintenance (PPM).
carry out maintenance the lightening protection in all the buildings inside
KAUST
Responding to any kind of meltdown
Ensure compliance with health and safety legislation
Maintenance of backup generators and ensure are work well
Collaborate with teams and co‑workers to always achieve desired results.
Maintenance and repair of sensitive devices and reprogramming to last version.
Soldering all of the small cables that connect inside “instrument inserts” and changing
the boards, sensors and fuse.
AC/QC all the special electronics and instrument tools of MWD drilling process.
Troubleshooting all electronics devices and writing reports about the any issues then
fix it.
Use the SAP systems to check history and descriptions for all the tools and update it .
Troubleshoot and Repair Electronics Systems, One of the main roles of an electronic
technician is to test and repair various electronic systems or instruments.
I run tests or fault diagnostics on equipment to locate and address a problem, order
parts if needed, and replace or repair parts.
This could include reassembling circuit boards, motor components, or other structures
within a system.
Install new electronic equipment and components and run initial tests on new
electronic systems or equipment.
This includes creating prototypes, identifying and avoiding potential issues, and
calibrating equipment as needed.
Troubleshooting for all the used batteries.
Build and rebuild all the batteries special for drilling tools rig in oil and gas.
Rewiring and soldering that connect inside batteries to devices.
Use the SAP systems to check history, Amp Hrs and descriptions for all the Batteries
and update it.
Carry out maintenance, diagnosis, and repair of electrical, automation,
and instrumentation of equipment applied by industrial motor controls,
chemical feed systems, pump drives, and the Supervisory Control and
Data Acquisition (SCADA) system
Carry out thermography of electrical distribution panels and motor
control
Troubleshoot problems by gathering and analyzing power quality data
Ensure longer life of obsolete equipment and save funds by carrying out
detailed troubleshooting down to component levels
Perform maintenance, installation, repair, and troubleshooting of control
centers, de‑energized higher voltage equipment, and 480 volt motors
Repair and maintain engine generators and carry out work on related
control circuit equipment
Carry out maintenance, repair, and installation of building circuits and
similar equipment
Perform maintenance of alarm and SCADA systems, electrical pneumatic
and electronic controls, programmable controls, and other similar
equipment