Davis Asuncion, Project HSE In-charge

Davis Asuncion

Project HSE In-charge

INMA Utilities and Contracting Company

Lieu
Arabie Saoudite - Jeddah
Éducation
Baccalauréat, Mechanical Engineering
Expérience
16 years, 9 Mois

Partager Mon CV

Empêcher usager


Expériences professionnelles

Total des années d'expérience :16 years, 9 Mois

Project HSE In-charge à INMA Utilities and Contracting Company
  • Arabie Saoudite - Jeddah
  • Je travaille ici depuis septembre 2013

 Prepare Job Hazard and Risk Assessment.
 Supervises and Implements the Company’s Health, Safety and Environmental Program.
 Be responsible for the implementation of all aspects of incident prevention, loss control program, fire prevention, and motor fleet incident prevention, control of equipment and property damages as well as first aid policies and procedures.
 Recommend corrective actions through pro-active job supervision initiate the cessation of work if a safe areas where there is eminent danger and stipulate necessary measure to take, to the permit resumption of work.
 Carry out site surveys to see it that only safe work methods are in operation, that health and safety requirements are being observe and that the welfare and first aid facilities are adequate and properly maintained.
 Foster within the company and understanding that the prevention of injury and damage control are an integral part of the business and operational efficiency.
 Inspect the worksite daily. Report and correct unsafe acts and conditions.
 Conduct incident investigation, analyze and formulate recommendations for corrective and prevention actions.
 Conduct daily surveys of construction operations to ensure compliance with client/ government safety standards and regulations. Identify safety defects and initiate corrective measure by
responsible supervision.

Safety Engineer à Al Rushaid Construction Company
  • Arabie Saoudite - AlJubail
  • août 2007 à mars 2013

 Responsible in implementing all safety aspects in conducting testing and commissioning activities.
 Be responsible for the implementation of all aspects of incident prevention, loss control program, fire prevention, and motor fleet incident prevention, control of equipment and property damages as well as first aid policies and procedures.
 Recommend corrective actions through pro-active job supervision initiate the cessation of work if a safe areas where there is eminent danger and stipulate necessary measure to take, to the permit resumption of work.
 Conduct incident investigation, analyze and formulate recommendations for corrective and prevention actions.
 Conduct daily surveys of construction operations to ensure compliance with client/ government safety standards and regulations. Identify safety defects and initiate corrective measure by responsible supervision.
 Advice management of the following:
h. Ways to improve existing work methods
i. Suitability of new hired equipment from safety viewpoint
j. Changes on safety requirement
k. Potential hazards on new contracts before work starts
l. Safety organization and fire prevention plans of the project
m. Work permits if necessary
n. Suitable security program

Safety Engineer à EEI Corporation
  • Philippines
  • mars 2007 à août 2007

 Prepare Job Hazard and Risk Assessment.
 Supervises and Implements the Company’s Health, Safety and Environmental Program.
 Be responsible for the implementation of all aspects of incident prevention, loss control program, fire prevention, and motor fleet incident prevention, control of equipment and property damages as well as first aid policies and procedures.
 Recommend corrective actions through pro-active job supervision initiate the cessation of work if a safe areas where there is eminent danger and stipulate necessary measure to take, to the permit resumption of work.
 Carry out site surveys to see it that only safe work methods are in operation, that health and safety requirements are being observe and that the welfare and first aid facilities are adequate and properly maintained.
 Foster within the company and understanding that the prevention of injury and damage control are an integral part of the business and operational efficiency.
 Inspect the worksite daily. Report and correct unsafe acts and conditions.
 Conduct incident investigation, analyze and formulate recommendations for corrective and prevention actions.
 Conduct daily surveys of construction operations to ensure compliance with client/ government safety standards and regulations. Identify safety defects and initiate corrective measure by
responsible supervision.

Éducation

Baccalauréat, Mechanical Engineering
  • à Western UniversityBinalonan National High School
  • avril 2005

Specialties & Skills

Group Training
System Safety
Safety Audits
Safety Engineering
CONTRACT MANAGEMENT
CPR CERTIFIED
ENGINEERING
FIRST AID
ORGANIZATIONAL SKILLS
PRODUCTION
SUPERVISORY SKILLS

Langues

Anglais
Expert
Tagalog
Expert

Adhésions

saudi council of engineers
  • Member
  • September 2013

Formation et Diplômes

Institution of Occupational Safety and Health (IOSH) (Formation)
Institut de formation:
Red Hawk HSE Training
Date de la formation:
April 2015
Durée:
40 heures