diaa eldin فؤاد

Make a handling for the location troubleshooting for process (2 );
 Vertical mill (Losche LM 60.6) with the capacity of 500 t/h and a fineness of 10% residue on 90µm .

 Preheater double string 5 stages, ILC Kiln with a dimension of 74*5 m, Pillard gas burner multi channel and a production rate of 5000 t/d.

 Two CF silo design (inverted cone) with blending extraction ratio to minimize chemical variation into kiln.

 Coal ball mill 33 t/h, air swept equipped with nitrogen generator as a suppression system.

 Using coal & natural gas in firing the kiln and LPFO for heating up.

 IKN grate cooler, one movable grate, 9 chambers supported by roller crusher.

 Monitoring the different parameters and variables in the central control room and achieve the stability level of safe and optimum operation.

 Following up the chemical and physical cement analysis in the laboratory and matching with the quality control targets for coal, raw meal, kiln feed and clinker characteristics .

 Familiar with Schnider PLC operating system & Chinese plant design.

for process (3 );
 Roller press system with the capacity of 300 t/h.

 Cement ball mill one compartment, central drive & a Blaine target of 3300 cm² / gm .

 packing plant, 10 packer machine.

 producing CEM I, CEM IIA 42.5 & CEM IIB 32.

attended the commissioning & start up period.

Make a handling for the location troubleshooting for process (2 );

 Sand slurry tube mill with the capacity of 19 t/h and afineness of 7 % residue on 45 µm .

 Raw ball mill equipped with a flash drier for drying the raw materials, single compartment, central drive, slide shoe bearing, a capacity of 140 t/h and a fineness target of 15 % residue on 90 µm .

 Preheater single string 4 stages, ILC Kiln with a dimension of 57*3.75 m, Duoflex gas burner and a production rate of 1500 t/d .

 A rotary Cooler Plant .

 Monitoring the different parameters and variables in the central control room and achieve the stability level of safe and running operation.

 Following up the chemical and physical cement analysis in the laboratory and matching with the quality control targets for slurry, raw meal, kiln feed and clinker characteristics .

for process (3 );
 Cement ball mill with the capacity of 100 t/h, two compartment, central drive, slide shoe bearing and a Blaine target of 4000 cm² / gm .

 packing plant .

 Operating on Vertical roller mill ( ATOX 25 ) for the raw material; Lime stone, Kaoline, Caf2 and slurry with the capacity of 100 t/h and a grinding target of 5 % residue on 90 µm .

 Two Sand slurry tube mill with the capacity of 8 t/h for each, turinion bearing, central drive and a grinding target of 3 % residue on 45 µm .

 Cement ball mill with the capacity of 80 t/h, two compartment, slide shoe bearing, side drive and a Blaine of 4200 cm²/gm .

 Cement packing plant.

also have a good knowledge of preheater ILC kiln operation enhanced by experience of PLC operating system and familiar with FLSmidth system .