إبراهيم الصعيدي

•I worked in different fields, assignment and holding many responsibilities within organization witch enhanced my knowledge and skills.

•I built my knowledge and experience during working with Maintenance department in daily activities and tasks as maintenance instrument engineer. My responsibilities include spot auditing, quality checking, technical evaluation and support on day to day activities related to maintenance PM & CM (such as transmitters failures, DCS Hardware Issues, Control Valves Failures).

•I built my knowledge and experience during working with Reliability department in major activities and assignments as Reliability instrument engineer. My responsibilities was including, troubleshooting, provide technical study report with recommendation, writing SOW and identifying the required Spare Parts on reported failures/issues such as:
 Issue related to DCS Logic & Relays (YOKOGAWA CENTUM VP)
 Issue related to Actuators / Positioners / Accessories of Control Valves & IGV’s (FISHER, ARCA, SIEMENS, FLOWSERVE, MAPAG, SAMSON, METSO, ABB)
 Issue related to Flow Transmitter (ROSEMOUNT)
 Issue related to Level Transmitter (ROSEMOUNT, ENRAF)
 Issue related to CO2 Analyzer (SERVOMAX)
 Issue related to Total Hydrocarbon Analyzer (SERVOMAX)
 Issue related to Vibration/Speed Probes and proximitors (BENTLY NEVADA, JAQUET).

•I built my knowledge and experience by been a Team Member/ Leader on technical meetings, conferences and assignments such as:
 Company Technical Day 2016 (Team Leader).
 Reliability Campaign 2015 (Team leader).
 Two RCA Workshops in 2016 (Team Leader).
 HAZOP Redo 2016 (Team Member).
 Control Valve Failure Analysis 2017 (Team Leader).
 Assets, BOM & PM Strategy (Team Leader).
 Plants Condition Assessment (Team Member).
 Plant Start-Up Issues (Team Leader).

•I have also built my knowledge and experience by involving in different activities such as:
 Participation in Commissioning Stage of NCP PH-III plant.
 Mark Up Drawing Drafting.
 MOC Initiation, Study and Execution.
 Yokogawa DCS Upgrading Project FAT & SAT.
 PH-II/PH-I Plant Shutdown and Start-Up
 Material Technical Evaluation.

• Researcher at National Nanotechnology Center at KACST.
• I built up my knowledge and experience by working with excellent professors at IBM Research Center in US and at KACST in Saudi Arabia as a part of a joint project in III-V conventional and flexible solar cells. My responsibilities include lithography, spinning, annealing, evaporation, etching, spalling, spattering, plating, and device characterization.

• I worked with the maintenance group as a team leader.
• During routine activities, my responsibilities included distributing jobs, troubleshooting, calibration, and routine maintenance activities for the following analytical instruments: PH, Sulfur, TGA, and GPC.

• I worked with a maintenance team to achieve department goals.
• During normal plant operation my responsibilities included diagnosing technical problems, troubleshooting, planning, calibration, and routine maintenance activities for the following instruments: Gas Chromatography, Gas Detectors, Portable Analyzers, and Online Analyzers.
• Worked on the PP III Project from pre-commissioning stage to implementation and operation. My activities included Vendor Liaison, Installation of Emerson GC’s, Detectors, Loop Checking (both Fiber Optic, and hard wire), Component Configuration, Initial Calibration, and Troubleshooting.