Technician
ICs
Total years of experience :9 years, 11 Months
Test and repair broken units from site,
* Soldering of PCBs, (SMD components, fine pitch
My design was based on test jig of a Power Amplifier control PCB which is using Arduino Due (32-bit) ARM based
Microcontroller. The microcontroller is controlling the logic sequence, that is sending 4 address bits and 8 data control bits
which will be controlling the multiplexer circuitry, harmonic filter circuitry and logic latch switch.
The demonstrator is designed to respond to the PC commands through a serial communication between PC Interface and
the audio filter. Ideally an ARM-core based, microcontroller development board is used to control the filter level of an
active audio filter (bass, mid-range, treble) via a PC interface. Output level verification will be demonstrated.
DOMAIN KNOWLEDGE
The following may assist me in doing the job at hand:
* Trouble shooting
* Soldering
* Basic Programming
* The use of various test equipment
* CAD (Multism, Proteous and Ultiboard).
installed
Primarily, my job was to help students with mathematics (1 & 2) and Electronics 3
September 2016 Coursework: Electronic Circuit, Computer Networking/Communications and Algorithms.