Senior Electronic / Instrument Technician
Woods hole group Royal Commission at Yanbu (RCY) (K.S.A)
مجموع سنوات الخبرة :27 years, 4 أشهر
•Perform regular calibration, configuration, preventive and corrective maintenance of environment air quality analyzers such as NOX, SO2, CO, O3, PM10, PM2.5 and VOC gas chromatograph analyzer (Thermo, Teledyne, Syntech and Environment S.A).
•Perform installation and testing of meteorological sensors.
•Repair electronic boards used in analog & digital instruments using SMD rework station.
•Write complete technical reports.
•Training Saudi Students of Yanbu Industrial College during summer period.
•Carry out, set up IP CCTV cameras at air quality monitoring stations (AQMS).
•Coordinate GSM communication modems (static IP modems )
•Conduct field inspections for industries and Royal Commission facilities.
•Carry out annual inventory of warehouse stock.
•Prepare new equipment specifications and spare parts list.
•Excellent Knowledge of ENVIDAS software.
•Coordinate and monitor spare parts supply with vendors.
•Performed preventive and corrective maintenance for air quality analyzers such as NOX, SO2, CO, PM10, PM2.5, NH3, O3 and VOC (Thermo, Teledyne, and Environment S.A).
•Performed installation, configuration, testing of GSM communication modems.
•Performed installation and testing of meteorological sensors.
•Performed test of temperature controllers, AC & DC drives.
•Knowledgeable in the use of sophisticated measuring instruments. Such as (Gas met analyzer)
•Excellent Knowledge of SAM-WI software.
•Trained Saudi Students of Jubail Industrial College during summer period.
Repaired Payphone main boards (Ascom - Schlumberger).
Maintenance, provision, installation, fault- finding, recovery, commissioning and modification on
the Telecom Egypt network provided by the Main Distribution Frame (MDF) Wiring.
Modified, faulty finding of (P.M.S) module boards, (Payphone Management System).
Excellent Knowledge of (P.M.S) V7 software.
Performed installation and repair of DSL lines.
Used monitoring tools to proactively support corporate customers Telephone and sit support to corporate customers.
Telecom device installation and configuration.
Modified, repaired digital electronic circuit and telecom cards such as (card reader, over voice module (OVM) etc. using SMD rework station
Maintained proper operation of ground radio, satellite, and telephony devices, including all Digital and Analog electronic components .
Extensive experience in AC/DC Theory and operation, as well as troubleshooting and repairing RF circuits down to component level using Schematics or approved procedures.
Installed and tested UHF- VHF receiver / transmitter portable radios.
Attended to microwave failures and doing microwave installations
Analyzed problems and repaired all electronic equipment & communications equipment.(Hard & Soft ware )
Maintenance and installation of solar panel power systems.
Conducted research and development concerning design, manufacture, and testing of industrial components, equipment .
Spliced wires and cables, using hand tools or soldering iron
•Repaired TV, VCR, CCTV monitors, and consumer electronic devices.
•Repaired AC/DC Power supply, Installed antennas and satellite dish receivers.
•Able to troubleshoot analog/digital circuits with specialized tools like digital, analog multimeter, dual-trace oscilloscopes, and logic probes. Repaired TV, VCR, CCTV monitors, and consumer electronic devices.
Repaired AC/DC Power supply, Installed antennas and satellite dish receivers.
Identified and resolved circuit, component and equipment failures .
Scrutinized and tested electronic equipment, parts and fabrications .
Utilized and maintained circuit testers and other electronic testing tools.
Calibrated and overhauled printed circuit boards
Developed electronic equipment designs
Technical Institute of Electronics & Telecommunication , Banha Egypt, May 1996