MD AQIL AHMED KHAN

site engineer at carrier

• India - Hyderabad
• June 2017 to December 2017

REAL TIME TRAINING in “MEP- Design and Drafting”
KG MECH Electro Mechanical Pvt. Ltd.

HVAC - Design & Drafting:
•Designing Work Ability - HVAC:
•Heat load calculation after building survey using CARRIER and ASHRAE standards by manuals and by latest HVAC ASHRAE E20 Form
•Calculation of blower CFM, air distribution duct design following SMACNA and DW144 duct design codes, selection of diffusers, grilles G.I sheet etc. (Mc Quay Software)
•To prepare the selection of machines like FCU’s, AHU’s, Chillers, Pumps etc, on the basis of Heat Load calculations from respective models like Blue Star, Voltas, and Carrier etc.
•Preparing the Air Distribution System for the complete design.
•Calculating the Duct Sizing according to the CFM by using Mc Quay Software
•Calculating the Pipe Sizing for the chilled water system according to the GPM.
•Preparing the BOQ for the complete project.
•Preparing the Equipment and Technical Schedule depending upon the project.
•Preparing Material Take-off (MTO) from tender drawings as per Specifications and International Standards.
•Incorporating the standards in the Shop Drawings and Sections
•Preparing the Schematic drawing for the project HVAC System Ducting and Chilled Water piping.
•Preparing the Pump Head Calculation for the selection of Pump Head.
•Preparing the Static Pressure Calculation fort the selection of AHU Fan capacity.
•Preparing the Shop drawings for Ducting and Chilled water system
•Preparing the Sections for the complicated areas and for the plant rooms.

Electrical - Design & Drafting:
Designing Work Ability - Electric65al:
•Maximum demand estimation and deciding voltage level.
•Selection of transformer/Dg capacity and number with necessary metering and protection.
•Preparation of detail main single line schematic.
•Short circuit & voltage drop calculation at each level of distribution.
•Selection of HT/LT switches gear based on breaking, making &short time capacity.
•Selection of HT/LT cables based on thermal, short circuit & voltage drop based ampacity.
•Preparation of GA/sectional drawings, HT & LT switch board and busbar sizing.
•Design of Earthing & Lighting protection system.
•Design of fire-safety in substation, cable trenches & other parts of electrical system.
•Preparation of power & control cable schedule.

Plumbing - Design & Drafting:
Designing Work Ability -Plumbing:
•Preparing Single Line Design Drawing for the Plumbing Systems.
•Designing of Water Supply & Sanitary Drainage System for a Building.
•Applying the Codes & Standards of Plumbing as per IPC.
•Preparing Double Line Shop Drawing for Water Supply & Sanitary Drainage System
•Preparing the BOQ for the complete project.
•Preparing the Equipment and Technical Schedule depending upon the project.
•Preparing Material Take-off (MTO) from tender drawings as per Specifications and International Standards.
•Incorporating the standards in the Shop Drawings and Sections
•Preparing the Schematic drawing for the project Plumbing System Water Supply & Sanitary Drainage piping.
•Preparing the Shop drawings for Water Supply & Sanitary Drainage system
•Preparing the Sections for the complicated areas.