QC Electrical And Instrumentation Inspector Engineer
Al Khonaini International Company
Total des années d'expérience :7 years, 10 Mois
Job Responsibilities in Electrical
⮚Monitoring the ongoing daily construction activities & coordinating with the construction team for the completed works which are ready for inspection / hold point release.
⮚ Inspect the completed works to ensure that the works are executed as per the approved IFC drawings, Shop drawings & specified / approved materials.
⮚ Conduct pre-inspection of electrical works (PVC Conduit Layout, EMT Conduit Layout, Wire Pulling, Wiring device installation etc.) prior for submission of Final Inspection with client.
⮚ Witness the Pre-com of MCCB/RCBO/RCD Trip Test and ensure that it comply as per manufacturer given value.
⮚ Inspect installation and construction of external underground cables, manholes, conduits and internal building distribution systems. Inspect all phases of the splicing and testing of cable systems.
⮚ Monitor and issue material receiving inspection for deliveries of power cable, panel boards, grounding, transformers and etc.
⮚ Visual inspection for preparation of cable trench prior to cable lying of power cables.
⮚ Conduct inspection for grounding system, conduit layout, power cable laying/pulling, installation of device and fixture etc.
⮚ Perform routine testing including Continuity and Insulation Resistance Test, Earth Resistance Test, Illumination Test, Polarity Test and etc.
⮚ Monitoring and updating the calibration of all Electrical and Telecommunication testing Equipment.
⮚ Reviewing the construction method statements and making comments per project specifications, procedures & ITPs.
⮚ Review cable and ground measurement test data for the basis of acceptance
⮚ Adapt in NEC, IEC, NEMA, ANSI, and other international standards applicable to our scope.
⮚ Coordination with Clients inspectors for getting the feedback for open log book entries and preparations of corrective actions to close those violations.
⮚ Perform proactive surveillance inspection to minimize and avoid discrepancy and non-conformance rectification cost and time.
⮚ Issuing of Non-conformance Report for any discrepancy found in electrical work.
⮚ Verify the site cleanliness and safe access for client inspections.
⮚ Verify the Inspection Test Plan (ITP) hold points and Prepare Request for inspections (RFI’s) and inform the client representatives to carry out the Inspections.
⮚ Coordinate with Construction team to rectify the comments (if any) from client representative before re-inspections.
⮚ To mark up the FIELD CHANGES in the shop drawings / IFC drawings this will be used while preparing the AS BUILT drawings.
⮚ Responsible for close-out of PMCC item prior to turnover.