حسن الشوبكي, Senior project Engineer

حسن الشوبكي

Senior project Engineer

'ALGHANIM INTERNATIONAL FOR TRADING AND CONSTRUCTION COMPANY'

البلد
الكويت
التعليم
بكالوريوس, Bachelor degree in Engineering (Civil Department)
الخبرات
16 years, 1 أشهر

مشاركة سيرتي الذاتية

حظر المستخدم


الخبرة العملية

مجموع سنوات الخبرة :16 years, 1 أشهر

Senior project Engineer في 'ALGHANIM INTERNATIONAL FOR TRADING AND CONSTRUCTION COMPANY'
  • الكويت
  • أشغل هذه الوظيفة منذ ديسمبر 2015

JV in Abdullah Refinery (December 2015 till current). JOB PROFILE: GENERAL BUILDINGS
-In charge of 3 buildings technical, laboratory and New ofice buildings with all structure and architecture works.
-In charge for Excavation & Mobilization works in Sabahiya Mall with Tamden Company.
-In charge of 8 health quarantine's at Jaber Al-Ahmed Army Hospital (concrete + steel structure)

Construction manger في Sinohydro
  • الكويت
  • أشغل هذه الوظيفة منذ أبريل 2023

مدير تنفيذي مسؤول عن ٥٩٧ قسيمه و ٢ مسجد رئيسي و ٢٨ محول كهربائي مع وزارة الإسكان بمشروع شرق صباح الاحمد

project Engineer in في 'ALI ALGHANIM & SONS COMPANY'
  • يونيو 2014 إلى نوفمبر 2015

agility and MPW projects (June 2014 till November 2015) JOB PROFILE:  GENERAL WORKSHOPS
-In charge of 75workshops including (concrete and steel) structures with agility project and in charge of brackish and freshwater tanks with MPW (central prison).

Engineer في 'ALGHANIM INTERNATIONAL COMPANY'
  • سبتمبر 2013 إلى يونيو 2014

JOB PROFILE:  GENERAL BUILDING
-In charge of three schools (kinder gratin & primary and intermediate) schools and three mosques (2) local mosques and (1) major mosque.  With 'ALGHANIM INTERNATIONAL COMPANY' at Kuwait as Construction

Civil Engineer في STEAM TURBINE BUILDING
  • أبريل 2010 إلى أغسطس 2013

JOB PROFILE:  UNDERGROUND FIREFIGHTING NETWORK AND GRP CW SYSTEM
-In charge of all piping activities for 5 kilometers of pipelines such as (ductile, recoated). The job included hydro test with diferent bars and commissioning the complete network.
-In charge of storm water line for this building.  With 'AZ ZOUR SOUTH CCGT-2' (gas turbines to combined cycle plant) JOB PROFILE:  STEAM TURBINE BUILDING 1- Setting out for the steam turbine. 2- Marking for the area to be excavated. 3- Investigation and rerouting for the existing services. 4- Excavation up to required levels as per piling work requirement. 5- Drilling for dewatering deep well. 6- Pilling work. 7- Shoring work. 8- Casting RCC rafts for both turbines.  BOILERS AREA
-In charge of all execution activities including (excavation work, RCC for ring footing with depth 2.5m and fixing anchor bolts for fix the boiler) and I have good experience in new type of concrete casting (slip form) I did it for the elevators that serves the boilers.  CENTRAL CONTROL BUILDING
-In charge of all execution activities including concrete works such as (Excavation, dewatering, blinding concrete, water proofing, isolated RCC foundation, columns, solid slab).
-Complete responsibility of finishing works, and handing over such as (block and brick works, cement plaster, epoxy and plastic paint, doors and windows, ceramic and terrazzo tiles, timber cladding, suspended ceiling, raised floor, …..etc).

"Head of Civil Engineers" في 'AGAM GROUP LTD COMPANY'
  • مايو 2009 إلى أبريل 2010

in SHUAIBA & ABDULLAH REFINERY of Kuwait National Petroleum Company (KNPC) (May 2009 to April 2010). JOB PROFILE:

"Head of Civil Engineers" في 'M/s AL-Meer Technical Services'
  • مايو 2008 إلى مايو 2009

- Impervious layer work, Surveying work for all tank area, Permeability test before and after supplying new catch, Compaction test.  Casting ring beam for TK/ 52- 153 so we are lifting the tank which is:
-Drilling H-Piles (3 m - 6 m) round Tank and tie with Beam, Support tank with jacks this jack have 3 legs one supported on pile 3m and other at 6m, Lifting tank by hydraulic jack slowly about 20cm per day this tank 500ton weight, Repair work round tank with steel 25mm, 12mm this steel I boxy steel., Shutting work for ring beam, Casting ring beam round tank.  AGAM Group L.T.D. 'SHUAIBA FACTORY'
-Design and execute sedimentation tank, Breaking floor slab and casting again for the entire factory.  With 'M/s AL-Meer Technical Services' at Kuwait as "Head of Civil Engineers". (May 2008 to May 2009). JOB PROFILE:  Modernization of Obsolete Instrumentation Project, PHASA- 1AT KNPC, MAA. Site supervision for the construction of KNPC and Al-MEER site ofices, Extensive survey for the modification of control room, Ensure safety measures at site, Coordination with client and subcontractor, Engineering works for modification of control rooms, Site engineer OMCCR site, Site engineer at DOHA site, Implementing temporary site ofices near various control rooms, Critical road crossings and duct bank installation, Providing material submittal for client approval, Preparing QA/QC documents and method statements, Taking proper work permits and authorizations, Conducting safety talks at site, Excavation work for cable trench.  M/S Al- Meer Technical Services CO.W.L. L 'DOHA and OMCCR SITE'. Excavation manually for extension control room, Shuttering work for PCC, Preparing for quantity of concrete, Shuttering and rebar work for RCC, Painting bitumen for RCC, Shuttering and rebar work for columns, Missionary work backfilling for bedroom, Shuttering and rebar work for first slab, Columns and roof slab, Missionary mission work, Plumbing and electrical work.

الخلفية التعليمية

بكالوريوس, Bachelor degree in Engineering (Civil Department)
  • في Faculty of Engineering, Mansoura University
  • يونيو 2006

Specialties & Skills

EXCAVATION
CONSTRUCTION
REFINERY
AGILITY
BOILERS
DEWATERING
MICROSOFT WINDOWS
SEDIMENTATION
CASTING
CLADDING (CONSTRUCTION)

اللغات

الانجليزية
متمرّس

العضويات

جمعيه المهندسين الكويتيه
  • عضو
  • January 2008

التدريب و الشهادات

البلديه الكويتيه (الشهادة)
تاريخ الدورة:
February 2024

الهوايات

  • الرياضه والقراءة