Ahmed Salama

Project: West Damietta Simple Cycle Power Plant 500 MW
(4*125) GE GAS Turbine
• AT Water Treatment, Installing all systems of low voltage and low current
(Lighting, Power sockets, Fire alarm and Communication)
• Assembly and test SF6 generator circuit breaker (Alstom) FKG-2M.
• Assembly and test step up (15/220 KV) Transformers (Hyundai Bulgaria) &
step down (15/6.6 kV) Transformers and NGR.
• Testing Current & Voltage Transformers
• Assembly and test isolated phase Busduct (Holduct Poland), GLAC and
GNAC.
• Install and test MV switchgears
• Install and test station-service transformers
• Pulling and termination power and control cables
• Testing Power Cables
• Scheme check for control and protection panels
• Testing auxiliary relays, MCB and MCCB.
• Testing simple relays (MICOM And GE)
• Testing battery charger And battery bank
Project: El Mahmoudia Simple Cycle Power Plant 330 MW
(2*165) GAS Turbine (Ansaldo)
• Assembly and test step up transformers (15/220) kV and step down
 Reading Electrical
Standards
 Ability for studying
continuously
 Think outside the box
 Effective at time
management &
prioritizing tasks to
achieve deadlines
 Ability to work under
pressure
 Flexibility in working with
different kind of peoples,
cultures and religions
 Adapting to changing
situations

To : Present
• Carrying out the Day to Day Commissioning activities of the Project at site
according to master plan.
• Reviewing all drawings & schemes and modify all design defects in order to
improve substation schemes.
• Familiar with most manufactures parameterization / diagnostic tools
(Siemens, ABB, Alstom, GE, SEL and Schneider).
• Excellent in reading schematic diagram, implement the drawing and doing
commissioning work for different type of panels in Electrical Substations
such as: LCC (local cubical control), AVC (automatic voltage controller),
Load Shedding, ACCS (automatic capacitor controller system). ABTS
(automatic bus transfer scheme), Line Protection, Transformer Protection,
Capacitor Protection, Bus-Bar Differential.
• Electrical Test work for all electrical equipment in all voltage level
(EHV, HV, MV, LV) inside electrical substations such as: Switch Gear
(insulation resistance test, CB test, DS/ES test, SF6 gas test, operation
interlock test, Gauges calibration test, Contact Resistance test and HV test),
transformer ( insulation resistance test, Tan delta test, percentage
impedance, winding resistance test, turns ratio test, vector group test,
Excitation current measurements, magnetic core balance test, Mechanical
protection test, oil breakdown test and tap changer test), CT&VT (ratio test,
polarity test, MEGGER test, winding resistance test, knee point test for
CT).
• Expert in Testing and programing all type of Main relays and control &
automation relays such as: Line protection relays (ABB RED670, Siemens
7SD522, SEL-411L, Micom P543), Transformer protection relays (Micom
 POWER SERVICE
(GIS-SWGR- CABLES

distribution
 Design and operation of
high voltage systems
 Reading relay’s manuals
 Well versed in the
application of full
electrical product cycles
power transmissions and
protection protocols
P643, SEL-487E, ABB RET670), Bus-Bar Protection relays (ABB REB 500,
Siemens 7SS522, Micom P741, P743, MCAG), ABTS & ACCS control relay
(REC670).
• Familiar with all Testing Equipment’s.
• Fault analysis report for all protection relays.
• Applying safety rules at site as per SEC standard (5 stars).
• Managing the weekly meeting.
• Discusses the cause of the possible delay and the proposed solutions to
overcome this delay.
Projects:
• RAS AL-KHAIR-3 380/115/33 KV BSP
• AL FADHILI GAS PLANT 380/115/13.8 KV BSP
• JUBAIL COMMERCIAL PORT 115/13.8 KV S/S 2
• NEW JUBAIL RESIDENTIAL 380/230/115 KV BSP
• RAS AL-KHAIR-1 380/115/33 KV BSP
• SWCC 380 KV BSP
• NEW AL-UQAIR 380/115/13.8 KV BSP
• SHEDGUM 2 380/115 KV BSP
• HAFR ALBATIN 115/13.8 KV S/S
• NEW SPARE LINES AT JUBAIL EXISTING S/S
• NEW SPARE LINES AT KHAFJI & NARIYAH EXISTING S/S
• MARITIME YARD 115/13.8 KV S/S

(15/6.9 kV) transformers (ETD)
• Assembly and test isolated phase Busduct.
• Install and test station-service transformers
• Pulling and termination power and control cables
• Install cable tray & conduits
• Installation of low voltage and low current systems (Lighting, Power
sockets, Fire alarm (Sanco) and Communication)
• Testing auxiliary relays, MCB and MCCB.

Egypt (NBE), Cairo, El Thawra
Branch.
• Liaising with companies about the ordering and negotiating the price of
materials
• Installation of Low Voltage and Low Current Systems, Distribution
Transformer, UPS, Batteries, Panels, Earthing and Emergency Generator as
Per Technical Designs and Drawings.
• Attend monthly progress meetings, develops status reports and deliver
presentation as required.
• Providing technical advice and solving problems on site
• Preparing site reports
• Review drawing and compare it with site condition and make as built
drawing
Training