Engineer- Condition Monitoring
Special Oilfield Services Co LLC
Total years of experience :11 years, 6 Months
To carry out vibration analysis of rotating equipment’s like steam turbines, generators, Motors, gearboxes, pumps, compressors and fans etc.
To report suitable recommendation for critical machines causing high vibration.
Trouble shooting the machine causing unbalance and take suitable corrective action.
Handling vibration analysis on low speed Machines below 600 rpm.
To Carryout RCA on frequent failure rotating equipment’s
To perform In-situ dynamic balancing of unbalance rotors.
Experience in online Vibration Monitoring system API 670 Machinery protection system SETPOINT
To carry out vibration analysis of rotating equipment’s like steam turbines, generators, Motors, gearboxes, pumps, compressors and fans etc.
To report suitable recommendation for critical machines causing high vibration.
Trouble shooting the machine causing unbalance and take suitable corrective action.
Handling vibration analysis on low speed Machines below 600 rpm.
To Carryout RCA on frequent failure rotating equipment’s
To perform In-situ dynamic balancing of unbalance rotors.
Worked on Turbine & generator High speed balancing facility
Arrangement of balancing weights required for balancing.
Carried out High speed Balancing Test of HP, IP, LPA, LPB Turbine Generator rotor at 150T capacity facility.
Carried out online vibration analysis of steam turbine & generator rotors
Experience on online vibration monitoring using Nyquist chart, weight effect chart and waterfall plot.
Trending & Monitoring the On shaft & Non-contact vibration levels
Trending of vibration level on test rotor’s critical speeds & rated speed, over speed test.
Reduce the vibration level as per design limits.
Worked on lube oil system (LOS), cooling water system (CWS) for the operation of steam turbine rotors and turbine generator rotors capacity of 600MW.
Maintaining lube oil flow, pressure and temperature for the operation of test rotor.
Worked on vibration probes installation, set according to preferred gap voltage
Carried out SOP for turbine rotor balancing operation.
Routine inspection of lube oil level in pumps and lube oil tank
Carried out vibration analysis of steam turbines, generator, gearboxes, pumps, compressors and fans etc.,
Trouble shooting the machine causing unbalance and take suitable corrective action.
Handling vibration analysis on low speed Machines below 600 rpm.
Proficient to perform FMEA, RCM worksheets.
Insitu balancing of rotors using 3 Point and vector methods.
Experience in online monitoring vibration system.
Exposure of laser alignment and review of wear debris analysis (WDA) and oil analysis report.
passed out in 1st class