إسحاق محمد

• Preventive Maintenance, Corrective Maintenance, Silica Gel Replacement and Field Servicing of
Transformers.
• Maintenance in transformer, substations, switch-gear
• Inverter installation and perimeter setting as per requirement
• Installation & commissioning of module, DC connection
• DC &AC cabling, testing, dressing, fer-ruling and charging
• Preventive maintenance and greasing of tracker motors according to schedule.
• CT and PT meter & RMU installation, connection and repairing
• Troubleshooting of all control, Power & lighting circuit.
• Using test equipment & hand tools to diagnose locate & fix electrical problems.
• Capacitor bank installation, maintenance, capacitor replacement and control the power factor
• Carrying out new project work, installation and Commissioning.
• Many types equipment installation, testing and calibration
• Interpreting work instructions, drawings and schematic diagrams.
• Laying of power cable (11KV) and testing
• Cable tray installation, field devices installation, on/off switches, field JBs.
• Continuity and Insulation test of cables.
• Design, develop, test power equipment and systems, industrial process control systems,
telecommunication, and circuits.
• Install, operate, and maintain electrical and electronic equipment and systems.
• Carry out predictive and preventive maintenance of Industrial Equipments.
• Routine visual Inspection to ensure equipment in good working condition.
• Set up and operate specialized and standard test equipment to diagnose, Faults and analysis the
performance of electrical and electronic components.
• Write specifications, schedules and technical reports and control schedules.
• Work under PTW system and have good practice of LOTO system where applicable.
• Inspect tools and maintain record of availability.
• Plant starts up and shuts-down monitoring. Experience in O&M of Solar power Plant.
• Experience in operating isolators, SF6 breakers, control and relay panel,
• Knowledge about transformer protection, HT and LT Cable Line.
• Attend Substation breakdown. Fault analysis and maintenance of plant equipments.
• Record maintenance and equipment reading updating. Involving project pending works.
• Commissioning & Responsible for breakdown rectification.
• Operation and maintenance of HT and LT Panels.

• Glanding & termination (0.75mm to 300 mm) power & control cables
• Disconnection and removal of the existing cables electrical control panel lights fitting and other
electrical equipments /components for renewal
• Dismantle and assemble of Motors
• Fabrication and fixing of support brackets necessary for installation
• Cable laying, Fabrication of cable tray & new for installation
• Installation of marine motor control center \[ MCC\]
• Termination connection and testing and commissioning
• Multi-meter, Megger, Phase sequence meter (live & dead), vibration meter and heat gun use properly
and safely.
• Instrument, F&G, PA/GA, HVAC and UPS system
• Installation of fire and Gas detection system
• Troubleshoot some electrical circuits and megger test
• Lighting, Star Delta connection, control panels & motor starters

 Overhead Working as a line man (440V) LV.
 Checking of all RC / DC Connection as per schedule.
 Connection Disconnection of CT meter three phase & single phase
 Installation and remove of electricity meter
 Arrangement for inspection, testing to ensure correct and proper installation of electrical system, which
includes wiring termination,
 Wiring of Single phase & Three phases Meters (Watt hour Meter)
 Installation of single phase & three phase meters (Watt hour Meter)
 Trouble shooting, checking, testing all equipment.
 Examined wires and auxiliary equipment such as fuses, insulators and switches to ascertain
 wires and auxiliary equipment on poles.
 preinstalled meter-connection boxes to connect service
 Inspected and tested electric distribution equipment and wiring outside and within buildings to verify
conformance of installation with construction and building code specifications.
 conformance to specifications on work orders.
 Approved installations and recorded inaccuracies on work orders.
 Tested lines, transformers and other distribution equipment, using such devices as