Senior process design engineer
Samsung Engineering Saudi Arabia
مجموع سنوات الخبرة :15 years, 2 أشهر
Heat and mass balance.
Extended Basic and Detailed engineering for refinery units.
Basic and detailed engineering for off-site and utilities.
Lines and pumps hydraulics.
P & ID Development
Thermal Design for shell and tube heat exchangers and air coolers by HTRI.
Equipment sizing such as KO drum and separators by In-house programs.
Sizing of safety valves and flare rating and evaluation by In-house programs and Flarenet.
Sizing of storage tanks PCV and PVRV and ERV as per API2000.
Preparation of Instruments datasheet and process datasheet for mechanical equipment.
Knowledge of international codes and standards in addition to ARAMCO standards.
Prepare and Update all process deliverables including, PID, PFD, MSD, C&E, Utility
Summary, Effluent summary, Chemicals Summary, Equipment list, Line List, Control
Narrative and Operating manuals.
Working experience in petrochemicals industry (Linear Alkyl Benzene production unit).
Provided comprehensive technical assistance for the Units (prefractionation unit,
Hydrotreating Unit, Molex Unit(SORBEX process), Dehydrogenation & hydrogenation
Units, Adsorption Unit, Alkylation Unit) during the units start up and normal operation.
Contributed in Units revamp to increase the unit’s capacity to 140 % of the nameplate
capacity through; Basic Engineering, Scope Study, PFD&PID and equipment layout, Review
basic engineering data and prepare data for invitation to bid.
Contribute in engineering and installation of new injection system;
- Basic Engineering; Conceptual study, reviewing PFD, P&ID, MSD and equipment
datasheet and change according to as built in site.
- Detailed Engineering; prepare Ti-in connections and piping hydraulic calculations,
invitation to bed, bid analysis, review bid and approval, purchases orders, precommissioning,
commissioning and system start up
Perform Management of Change (MOC) and optimize the unit’s productivity.
Carried out process engineer tasks; Safe process operation, controlling process operation,
respond to abnormal conditions and provide support for management and unit KPI.
Troubleshooting and monitoring the unit’s equipment performance (Fired Heater,
Compressor, Heat Exchangers, Air Coolers and pumps).
Following Up Catalyst Loading Activities and preparing technical loading reports.
Perform process-engineering calculations and simulations.
Monitoring Distillation Columns performance and perform sizing.
Trained on the control system YOKOGAWA system Centum 3000.