process engineer-operation engineer
TCI SANMAR for petrochemicals industry
Total des années d'expérience :16 years, 6 Mois
Working from 2009 till date at TCI Sanmar Port Said, a large Petrochemical Complex having a capacity to manufacture 4.LAKH Tons of PVC per year, starting from production of Ethylene plant from Ethanol, then export it to EDC plant, after that start VCM production process .
Work attending at TCI Sanmar plant:-
1. Erection.
2. pre-commissioning (piping, equipment, rotary equipment, instrumentation, flushing with water, steam blasting, air blowing, nitrogen purge, installation of safety valves, loading of column packing, seal test, instrumentation test )
3. commissioning
4. plant cold tests
5. start up
6. plant shut down
7. refractory dry out
Duties as shift in charge in Ethylene Di Chloride (EDC) unit 2015 - till now
EDC ECOS technology main process:
• LTC reactor
• EDC washing system, light ends column& waste water stripper
Duties as plant Operator in INCINERATOR unit 2011-2015
Incinerator PF EUROCOM technology main process:
• Combustion chamber section
• Steam generation section
• HCL recovery & treatment
Duties as field Operator in VCM unit 2009-2011
VCM INEOS technology main process:
• EDC washing system & waste water stripper
• EDC cracking & VCM purification
- Responsible for safe operation of the equipment in assigned area and to maintain plant within Design limits so as to sustain. maximum production
- To ensure HSE policies and procedures compliance (Permit to Work, Environment Management Systems, OSHAS etc) in the shift.
- To perform Atmospheric Gas Testing. Discharge responsibility as Emergency Response Team Member if nominated.
- To Carry out all field activities in case of:
1. Normal Plant Operation
2. Start up and shut down
3. Plant emergency
work with team health & safety environment in Pharmaceutical industry
- May 2007Alexandria University Egypt. - Faculty of science, chemistry-geology (double course), geology department - Post graduate studies: (Natural gas Diploma) in July 2010 Process safety 1. Fundamentals 2. Equipment used for gas processing Mass transfer, heat transfer, momentum heat exchangers, absorption, adsorption fluid mechanics, thermodynamics lle, flare ,separators(k.o.drum-scrubbers) gas processing, automatic control distillation(fractionation-stripping) 3. Natural gas processing course 4. Simulation LNG, trouble shooting, NGL pro ii, reading drawings (pfd, data sheet new technologies for N.G.P piping and instrumental diagram, Fractionation (towers included) isometric, mechanical drawing) Treatment, fundamental HYSYS 5. H S E HAZOP HAZID (hazard identification), PHA (process hazard analysis), FTA (fault tree Analysis) RCA (root cause analysis), FMEA (failure mode of effect analysis), SIS (safety instrumented system), SIF (safety instrumentation function) SIL (safety integrity level) OSHA 6. HAZOP, requirement courses (IEC required 61511, 61508) Piping (ASME, ANSI codes) Corrosion, valves, pumps, towers and automatic control . ICDL - Skilled computer management &upgrading my level continuously Very good command of both written & spoken English. # work in TCI SANMAR for petrochemicals industries Operation chemist in VCM unit and INCINERATOR unit # Alexandria Petroleum Company training for three months