Zeshan Shaukat

• Act as first-line maintenance engineer for automated equipment: selective soldering, wave soldering, CNC
punching/bending and AI-based AOI.
• Diagnose electrical faults, wiring failures, sensor issues, heating element faults, pump blockages, drive faults
and PCB fixture problems.
• Perform mechanical repairs including actuator replacements, conveyor adjustments, alignment corrections,
motor inspections and lubrication.
• Carry out preventive and predictive maintenance, reducing breakdown frequency and improving system relia
bility.
• Commissioned, programmed and integrated new wave soldering line; created machine profiles, parameters and
full engineering documentation.
• Installed and set up selective soldering line; programmed solder paths, developed maintenance sheets and
trained operators.
• Delivered AI-enabled AOI project from procurement to deployment; created vision inspection routines im
proving defect detection.
• Optimised CNC operations by redesigning panels, improving tool paths and reducing cycle time through
efficient sequencing.
• Produced SOPs, maintenance logs and troubleshooting guides; trained operators and junior engineers in first
line diagnosis.

• Performed service, repair and calibration on robotic assembly systems and automated machinery.
• Troubleshoot PLC signals, sensors, actuators, pneumatic systems and robotic end-effectors.
• Restored robotic cells to full operation following mechanical, electrical or software-related failures.

• Installed and tested fire alarm, CCTV and access control systems; completed continuity checks and commis
sioning procedures.
• Assisted in layout design and engineering planning using AutoCAD and Revit.