Waqar Muhammad

Activities:
Busbar protection Differential, Stability Sensitivity Primary injection, overlap CT
Transformer Differential 7UT85 Relay testing
Feeder protection Relay 7SJ81, 82 configuration Testing
Interlocking Up stream &Down Stream
Intertrip Upstream & Down Stream
Functionality & Interlocking Arc trip, Lockout, Breaker failure
Auxiliary. Relay testing (Arc trip, Lockout, DC supervision)
MCB testing
CT testing( IR Test, CT Analyzer)
PT testing (IR, Ratio tests, winding resistance, polarity, primary injection)
VCB testing (IR, Timing, Contact resistance, Functionality, Hipot)
Busbar Testing (IR, Contact resistance, Hipot)
Space heater testing
Earth switch inspection and Functionality
EQUIPMENT USE:
CMC (Omicron)
FREJA300(Megger)
Serverker 900(Megger)
CPC100(Omicron)
CT Analyzer (Omicron)
Egil (Megger)
MicroOhmmeter (Megger)
BAUR (Hipot kit)
SOFTWARE
siprotec 5 DIGSI-5
Test Universe
CT Analyzer software
Documentation

Implement procedures to improve process efficiency and reduce project duration.
Coordinate with other departments to ensure efficient operation of electrical systems.
Performed various managerial duties such as ordering supplies preparing reports, and maintaining an effective filing system.
Supervising electrical staff and coordinating the daily activities of the electrical department.
Prepared detailed test reports, including dataanalysis, observationsand recommendations.
Visiting different remote client sites to oversee the testing of equipment
Supervising the transition from installation to operational use.
Providing training and operational guidelines to end-users or operators.
Conducting performance optimization and system upgrades if required.
Responsible for ensuring that all equipment is maintained and up to international and local standards, codes, and regulations
Inspect electrical systems and equipment to identify hazards and
ensure compliance with codes.
Assisted engineers, project manager in review approval and archiving of all closeout documents.
Responsible for continuous safety programs, loto, arc flash safe work.
Ensuring that on site Health &safety are strictly adhered to.
Ensure that calibration is done of All testing equipment.
Proficient in computer-aided design (CAD) software for electrical systems.
Read and interpreted SLD, Schematics, control wiring diagrams
Conducted and documented testing of electrical equipment suc as MVswitchgear, transformer, cable, LVswitchgear, MCC, SDB etc.
Assisting in system handover to the client.

Testing and commissioning of HV/LV electrical systems

Transformer testing (oil tests, SFRA tests, Tandelta tests, ratio tests, polarity test, winding resistance
CT Analysis test)
Relay protection testing (overcurrent, distance, differential protection)

Circuit breaker testing (timing tests, contact resistancetest, insulation resistance)

Busbar Testing (Insulation resistance test, contact resistance test, HIPOT test)
Cable testing (megger, hi-pot, and VLF tests)

Electrical Systems Expertise
Proficient in working with MVswitchgear LV switchgear, motors, Transfermers and generators

Power system fault analysis and troubleshooting

SCADA, PLC, and control panel configuration

Knowledge of grid synchronization and load sharing systems


Tools & Equipment

Omicron CMC, Megger, and Doble test kits

Primary and secondary injection test kits

Multimeters, oscilloscopes, and power quality analyzers

Good knowledge in AutoCAD, ETAP,


Standards & Compliance

Familiarity with IEC, IEEE, and ANSI standards

Ensuring compliance with electrical safety regulations

Knowledge of electrical commissioning protocols and documentation


Safety & Problem-Solving

Adherence to HSE practices and risk assessments

Root cause analysis and troubleshooting of electrical faults

Experience in preventive and corrective maintenance


Project Management

Scheduling and planning of commissioning activities

Coordinating with cross-functional teams and stakeholders

Documentation and reporting of test results and commissioning records