QA
JV PSH (PORR /SBG/HBK)
Total years of experience :20 years, 10 Months
Conducting the quality induction training about the work and ITP requirements to the site team from project engineer to foreman prior to commence any activity as per method statement.
•Performing all material inspection on site for conformance with project specification.
•Involving site inspection for enabling works such as rocknail grouting, shotcrete, ground anchor, piling work and dewatering as per drawings and specifications.
•Witnessing the survey and setting out, monitoring the piezometer reading for water level and inclinometer and 3d prism for subsurface movement.
•Witnessing the third party testing such as rocknail pull out test, ground anchor suitability test.
•Inspecting the below and in-slab earthing and drainage pipe installation, witnessing the continuity test for earthing and gravity, pressure test for drainage pipes.
•Witnessing the third party testing for compaction test (Nuclear Gauge test method) for each compacted backfilled layer and performing the plate load test for the final layer.
•Inspecting the structural activities like rebar installation for raft foundation, sump pit, retaining wall, column and internal elements as per drawings requirements.
•Inspecting all types of waterproofing from raft foundation to roof for underground station, evacuation shafts, cross passages and underpass-NATM
•Inspecting post-concrete for defect assessment and repair works as per MS requirements.
•Inspecting the tunnel segment installation, assessing the defects and preparing the assessment reports for the repair.
•Involving site inspection for underpass-NATM (New Austrian Tunnelling Method) such as excavation and support works (Pipe umbrella installation, shotcreting, rocknail grouting, niche filling and profiling), formwork for inner-lining, rebar installation.
•Checking of concreting for slump flow, slump and temperature and verifying the delivered concrete as per approved design mix along with the required number of samples.
•Involving site inspection for architectural work such as Non-bearing block work installation, lintel and stiffener beams, plastering, un-bonded/bonded floor screed, upstands and plinths, painting (Emulsion, epoxy and anti-dust sealer), dry wall, vault, wall cladding, petal ceiling installation and tunnel walkway installation
•Attending various site inspection with client and consultant as per project protocol.
•Well versed with QCS2010(Qatar Construction Specifications), BS and BS EN
•Verifying the agreed proposed remedial action, cause and proposed action to prevent recurrence from Station Manager.
•Maintaining QA/QC documents of entire project including certificates, calibration, test results, Site inspection requests, Material inspection request, non-compliance reports, site observation reports and other QA/QC documents.
•Preparing Snag list for finished work with client’s representative along with the site Manager by mobile online SNAGR and making summary for complete/incomplete activities.
Project Involvement:
•Metro-Greenline Underground project, Qatar
•(The project comprises of 7 underground stations, 2 Switch boxes and 6 Evacuation shafts along with 16.6Km of tunnel and 7 km of elevated metro. And the project value is 2.5Bn USD)
•One of seven packages included in phase one of the wider Doha Metro, which will be operational before the FIFA World Cup, Qatar 2022. This project consists of 16.6km of twin-bored tunnels built at a depth of 20 meters. The line spans from Mesheireb (Central Station) through to Education City and on to Al Rayyan and track will run underground. The Green Line Project is also known as the Education Line due to the fact it will run through the Qatar Educational Institute. Twin Bored Tunnel: 16.6 km total length passing through three major stations. Station Boxes: 6 nos. with a total length of 2.8 km Evacuation Shafts: 6 nos. along the alignment. Cross Passages: 55 nos. underground between the two tunnels Tunnel Ring Segments: 20, 586 pcs. of precast segments. Tunnel Boring Machines: 6 nos. (Dia.=7.1m, L=110m) operating simultaneously
As QA/QC Inspector, execute the inspection as per specification using applicable tools and equipment.
Raise RFI for specified work for approval prior to proceed with the next work activity.
Raising Field Inspection and Materials Inspection request and join with the inspection at site.
Strictly Implements the Applicable Procedure and Requirement( SAES)
Issuance of NCR for non-conforming work as against to the approved specification and or Standards.
Dissemination of work activities to work force align in project schedule and commitments.
Supervision and monitoring of project ensuring that it is properly under the approved drawing and specification.
Attend operations coordination meeting to prevent hampering of project execution.
Impose and implement company policies, ensure strict compliance with the rules and regulations as well as safety within the project site.
Monitoring of project accomplishment and progress of project and report to Project Manager
Prepare respondents, reports, queries and documents relative to safe and proper project execution using Microsoft application in computer.
Check of layouts for verification, actual as against approved drawing plan.
Took assignments from QC Manager and execute all as against as required in specification and as per approved drawing.(IFC drawing) and Approved method Statements
Monitoring of actual progress accomplishment on site
Dissemination of work activities to work force align with the project schedule and commitments.
•Supervision and monitoring of project ensuring that it is properly under the approved drawing and specification.
•Attend operations coordination meeting to prevent hampering of project execution.
•Impose and implement company policies, ensure strict compliance with the agreed rules and regulations as well as safety within the project site.
•Monitoring project accomplishment and progress for weekly reporting
•Prepare respondents, queries and documents relative to safe and proper project execution using Microsoft application in computer.
•Check of layouts for verification, actual as against approved drawing plan.
•Involve in execution of water field-testing on curtain wall and on windows.
Project Involvement:
•MDC 100 Eastwood Center, Quezon City
•East Tower @ One Serendra
Prepare plans and programs, work schedule, work force, tools and equipment requirement of the project.
•Supervision and monitoring of project ensuring that it is properly under the approved drawing and specification.
•Coordinate with the higher authorities concerning confirmation and other queries before the execution of the project.
•Impose and implement company policies, ensure strict compliance with the agreed rules and regulations on the project site.
•Formulate ways and means to improve existing work standard towards greater output.
•Prepare materials schedule for windows, curtain walls and claddings of the propose project.
•Make installation work procedure align with the actual condition of the work area.
•Make sure of proper implementation of safety rules and regulation on the project.
•Coordinate with the management concerning affected areas during installation and water leak testing execution.
Project Involvement
Prepare plans and programs, work schedule, work force, tools and equipment requirement of the project.
Supervision and monitoring of project ensuring that it is properly under the approved drawing and specification.
Coordinate with the higher authorities concerning confirmation and other queries before the execution of the project.
Impose and implement company policies, ensure strict compliance with the agreed rules and regulations on the project site.
Formulate ways and means to improve existing work standard towards greater output.
Prepare materials schedule for windows, curtain walls and claddings of the propose project.
Make installation work procedure align with the actual condition of the work area.
Make sure of proper implementation of safety rules and regulation on the project.
Coordinate with the management concerning affected areas during installation and water leak testing execution
and monitoring of project ensuring that it is properly under the approved drawing and specification
•Coordinate with the higher authority concerning confirmation and other queries before the execution of the project.
•Impose and implement company policies, ensure strict compliance with agreed operating procedure on the project.
•Close monitoring of heavy equipments such as Generators, Compressor, Service Vehicles, Crane, Forklifts, Welding machines, etc, for preventive and corrective maintenance.
•Acted as Safety officer in the Project to monitor the safety of the workers as well as working area of the project.
•Assist the quality control officer in the application and execution of testing such as vacuum, hydro test, oil leak testing, NDT etc.
•Prepare and monitor of the progress accomplishment of the project for billing purposes.
Project Involvement:
•2-units Diesel Tank and 1-unit Fire Water Tank @ Tabuk Power Plant, KSA
•PP-9 Power Plant (participates in the maintenance of heavy equipment used
Site Inspection, prepare erection/ installation budget, plan, project schedule with work force and equipment loading, and preparation of tools and gadgets.
Supervision and monitoring of project ensuring that it is properly under the approved drawing and specification.
• Monitor the project execution, ensuring that approved erection methodology and procedure are properly aligning with the plan and schedule.
•Coordinate with the higher authority concerning confirmation and other queries before the execution of the project.
•Assist in survey, verification and inspection for the alignment of structures prior to installation.
Project Involvement
Supervision on fabrication and erection of elevated water tanks
•Supervision on fabrication and installation of steel trusses for building, gymnasium, bridges, etc..
•Supervision and monitoring of project ensuring that it is properly under the approved drawing and specification.
•Monitor of project execution, ensuring that fabrication and erection procedure are properly aligned and safe.
•Coordinate with the higher authority concerning confirmation and other queries before the execution of the project.
Project Involvement:
•Structural Steel trusses of twin building in Forbes Park, Makati
•Structural steel Bridge in Fort Bonifacio
•Elevated Water Tank in Queens Borough, Mexico Pampanga
•Structural Steel Poles in Quezon City, Golf Range
Assist in the Supervision and monitoring of project execution to ensure that the work is properly in order as per approved plans and specification.
•Monitor the materials for the project as per requirement and specification.
•Coordinate with the higher authority concerning confirmation and other queries before the execution of the project.
•Report to immediate superior regarding queries and problem encountered along execution.
execute the inspection as per specification using applicable tools and equipment.
•Raise RFI for specified work for approval prior to proceed with the next work activity.
•Raising Field Inspection and Materials Inspection request and join with the inspection at site.
•Strictly Implements the Applicable Procedure and Requirement( SAES)
•Issuance of NCR for non-conforming work as against to the approved specification and or Standards.
•Dissemination of work activities to work force align in project schedule and commitments.
•Supervision and monitoring of project ensuring that it is properly under the approved drawing and specification.
•Attend operations coordination meeting to prevent hampering of project execution.
•Impose and implement company policies, ensure strict compliance with the rules and regulations as well as safety within the project site.
•Monitoring of project accomplishment and progress of project and report to Project Manager
•Prepare respondents, reports, queries and documents relative to safe and proper project execution using Microsoft application in computer.
•Check of layouts for verification, actual as against approved drawing plan.
•Took assignments from QC Manager and execute all as against as required in specification and as per approved drawing.(IFC drawing) and Approved method Statements
•Monitoring of actual progress accomplishment on site.
Project Involvement:
•Hospital Building in Ar-ar Saudi Arabia
•School for Girls Building in Najran Saudi Arabia
Middle East such as Inspection of materials, testing & inspections of Embankments (subgrade and Base coarse materials) Aggregates / rocks; inspections of reinforce steel bars for the concrete structure such as Dam face, wave wall, diaphragm and footings, including coring/drilling, including inspections for reinforce concrete road and asphalt road, Tunneling (NATM) cross passage, station and including architectural finishes, and 15 yrs in field as Civil site engineer for Structural Steel Construction/ Infrastructures in reputed organizations in Philippines. Familiar with the Erection, Fabrication of structural steel (welded and bolted connections) for bridges, storage tanks, space frame and other steel structures, including architectural finishes such as curtain wall (glass panels), aluminum composite panels, door frames and windows (frameless, semi and framed