QCengineer
zamil offshore co
مجموع سنوات الخبرة :9 years, 5 أشهر
1. In-depth technical knowledge in composite ship repair including, technical drawings, specifications, etc.
2. Strong knowledge of ship repair quality management system and standards.
3. Make non distractive test for weld (ultrasonic, magnetic particle and interpretation of radiograph films for weld)
4. Check and repair all valves types (non- return, globe, gate …, etc.) and tested after repair.
5. Check, repair and measurement anchor and chain cable.
6. Inspection and calibration the propeller shafts and stern tubes.
7. Inspection and calibration the rudder stock, pintle and rudder shoe.
8. Measure the propeller shaft wear down by using poker gauge.
9. Make a procedure for welding copper alloy propeller blades according to IACS Rules.
Ship Building works:
1. In-depth technical knowledge in composite shipbuilding including performance, stability, technical drawings, specifications, etc.
2. Strong knowledge of ship building quality management system and standards.
3. Check all dimensions and inspection weld of all frames, BHDs, keel plate, longitudinal girders, shell and deck plates of craft according to drawing before erected and leveling on jug.
4. Make tightness test to verify the areas of the hull exterior and interior water tight (BHDs, hatches, doors... etc.) don’t leak.
5. Read drawing and manufacture all pipe lines according to drawing and test all systems to demonstrate the strength and tightness of pipe lines.
6. Tested tanks to verify them have no leak and structurally sound.
7. Tested mooring fitting to verify that the mooring and towing fitting meeting the strength requirements.
8. Check propulsion system alignment to verify proper alignment of propulsion engine, propeller and reduction gear by using dials indicators and feeler.
9. Make speed trail for engine to determine the speed of craft at a various engine power rating, the dynamic trim and fuel consumption.
10. Make under way propulsion plant to demonstrate satisfactory operation of the propulsion system and their accessories.
11. Check alarm monitoring system to verify proper operation of main engines and generators alarm systems.
12. Check steering system to demonstrate proper operation of the steering system and its alarms.
13. Make under way steering and maneuvering to demonstrate proper operation of the steering system.
14. Check all pump systems to verify the installed pumps operation.
15. Check life and safety equipment to verify the life saving and safety equipment has been provided and properly stored.
16. Make craft fueling demonstration to verify satisfactory fueling of the craft with use outside source.
17. Make Inclining Experiment to determine the inclining angle of craft.
1. In-depth technical knowledge in composite ship repair including, technical drawings, specifications, etc.
2. Strong knowledge of ship repair quality management system and standards.
3. Make non distractive test for weld (ultrasonic, magnetic particle and interpretation of radiograph films for weld)
4. Check and repair all valves types (non- return, globe, gate …, etc.) and tested after repair.
5. Check, repair and measurement anchor and chain cable.
6. Inspection and calibration the propeller shafts and stern tubes.
7. Inspection and calibration the rudder stock, pintle and rudder shoe.
8. Measure the propeller shaft wear down by using poker gauge.
9. Make a procedure for welding copper alloy propeller blades according to IACS Rules.
mechanical engineer
faculty of engineering, mechanical power department, Alexandria University. Graduation in:74.15