Hani Khomaies

Perform hands-on role by providing guidance and technical support to the
project HSE Senior Engineer.
 Participate in introduction of safety culture at site/project, Proper take over/hand
over of shifts.
 Review End of Shift Safety Report (ESSR) of previous shift.
 Coordination with contactor & consultant safety representative for site visit and
find solution to urgent, critical safety issues.
 Carry out Hazard Identification, note non compliances and other safety issues.
 Communicate identified hazards and required safety measures to contractor
safety and execution teams.
 Follow up for the pending issues of previous shifts and coordinate unresolved
issues with next shift.
 Monitor & report the effectiveness of Contractor Permit to work (PTW) system.
 Participate and support as needed in investigations and accident analysis and
recommend corrective preventive measures.
 Implement a process to ensure that contractors work within the HSE legislation
and abide by all project HSE practices and procedures.
 Provide a safe working environment & ensure effective coordination, send
effective coordination between execution & safety team.
 Prepare ESSR & update Excel Sheet, Upload these documents in share folder &
copy to responsible HSE Senior Engineer, making sure all documents have been
completed and saved.
 In case of any nonconformity detected, Issue Improvement Notice (IN), Non
Conformance Report (NCR) & Stop Work Notice (SWN) as per site safety issues.
 Communicate all these notices within the team, Ensure that notices issued are
effective.
 Ensure Work Resumption Order (WRO) has been issued after complete
rectification of comments and in consultation with area HSE Senior Engineer.

I was assigned as Application Engineer;
- Responsible for collection of inquiries, selection of equipment "chillers, AHU and FCU" / load calculation &
load estimation, calculating prices and preparing offer, also Liaise with Consultant.
- Responsible for assisting Sales Engineers in preparation of Offers/Technical submittals/ clarification and/or
technical liaising with approved sources as required.
- Responsible for supporting & assisting Consultants (customer’s representative) in getting the products
specified.

To assist the Sales Engineers in preparing quotations
To assist Sales Engineers in technical submittals/clarifications as and when required.
To visit and assist consultants in getting Carrier specified.
To prepare the necessary and relevant branch reports.

Filed mechanical engineer in central utiltiy plant in KAU - CUP-2

I was assigned as Mechanical Field Engineer in;
- CN8.400-Central Utility Plant II-Phase I
- CN8.500-Central A/C Plant II Electromechanical work
- CN8.600-CUP II for new Academic Square Building
- CN8.700-Ice Storage Tank for A/C Plant
- CN8.300-KAU Water Tank
Supervise HVAC installation work on site as per engineering drawings and site conditions.

Trainee as Mechanical Engineer

Power Plant # 3, Jeddah