Safety Advisor
saudi aramco
Total years of experience :11 years, 10 Months
Advise management on loss and fire prevention policies, standards and procedures, and recommend changes that
can improve risk management programs.
o Review long-range trends in loss/fire prevention engineering and advise management on a company response to
these trends.
o Research emerging safety technologies and conduct feasibility studies and cost analyses to identify improved
solutions to existing safety problems and emerging regulatory requirements.
o Act as an expert safety resource for risk identification and mitigation during design, construction,
commissioning, turn-over to operations, on-going operations, management of change and decommissioning of
facilities.
o Review existing company standards, procedures and instructions and recommend cost effective safety enhancements
to facilities to align them with the latest international standards.
Working as a Safety Engineer for Al Othman Consultants at ARAMCO Southern Area Oil Operation (SAOO) Projects with saudi Electricity Company from 24 August 2016 to till date.
Responsibilities as Safety Engineer.
- Review/revise and ensure implementation of project-specific safety Management plan on site that is in compliance with national and international standards.
- Review initial safety indoctrination programs for new employees.
- Review safety audits to measure effectiveness of safety controls and report to the Divisional Manager on any non-conformances found during the audits.
- Cooperate, communicate and coordinate with the Divisional Manager in the effective implementation of HSE Management policy.
- Ensure that all necessary proactive safety measures are developed at the onset and are implemented during the course of the project.
- Carry out site inspection before testing and commissioning of High voltage (HV) feeders and lines.
- Permit controller for working in energized area.
- Record and follow up on any noted safety hazards.
- Review and approve the contractors HSE documents, submittals etc. to verify their suitability, adequacy and conformance with project specifications and applicable safety standards and Regulations such as OSHA, NFPA.
- Actively mentor co-workers and contractor employees to improve HSE performance.
- Investigate the causes of accidents/incidents and provide recommendations and guidance to avoid recurrence.
- Review Job Safety Analysis (JSA), Risk assessment, and safety audit/inspection.
- Reviewing contractors/sub-contractors pre-qualifications based on HSE criteria and thereby assisting in contractor selection process.
- Identification of HSE training needs for the contractor and subcontractor staff and workers.
- Develop/Review/Revise Emergency Response Procedures (ERPs) and Emergency Evacuation Procedures (EEPs).
- Generate non-conformances (NC) and HSE violations & site memos regarding the unsafe undertaking of work on site.
- Conduct inspection of scaffolds and form-work and ensure their compliance with design and relevant local/international standards.
Responsibilities as HSE Engineer at DAHP.
- To enhance the existing Safety Management System in company.
- To ensure compliance with company's objectives, requirements, priorities, policies, procedures, standards, rules, regulations and guidelines provided by company from time to time.
- Facilitate the development and execution of the Site HSE Plan.
- Advising employees about safe & healthy work practices & management systems.
- Creating effective procedures for the preparation and implementation of programs within the area of Construction safety, and the environment in process.
- Inducting all the employees & visitors.
- Support & monitoring of Safety Performance.
- HSE Inspections, Accident/Incident reporting & Investigation, analysis of incident statistics in order to identify trends and propose the necessary corrective measures & follow-up.
- Identifying potential hazards and document the same.
- Ensure that the Company’s Health and Safety policies and procedures are communicated to the employees
- Carrying out weekly HSE inspections with client & consultant.
- Monitoring all safety issues on site, to prevent and stop dangerous work practices.
- Periodic checking of all fire fighting equipments & conducting mock fire fighting drills.
- Helping in identifying and eliminating unsafe conditions and maintain complete work field safety, maintain proper housekeeping.
Responsibilities as HSE Engineer at KAFD
- Co-ordinate with the Client Representative and Consultants to improve HSE Requirements on Site.
- Co-ordinate with Project Managers and Construction Manager to implement Safety Plan on Site.
- Attend Weekly Meetings with the Clients and Consultants & Core Team.
- Co-ordinate with Sub-contractors to implement HSE Work Procedures on Site.
- Planning and Managing periodical inspections & maintenance schedule according to vendor’s specifications to all Safety & Fire Equipment.
- Accident, incident Investigation and Reporting.
- Daily, Weekly, Monthly, Quarterly inspection and Monitoring all activities and facilities.
- Defining to Company Management any need of special emergency, rescue, safety and fire protection / firefighting systems and necessary training.
- Support Company Safety, Environmental and Quality policies and programs, Provides technical and professional proposals and advice to protect company property and personnel.
- Fire prevention of all activities, testing of smoke and heat detectors, conducting drills. Check-up Breathing Apparatuses sets.
- Supervision of all construction works on site.
- Preparation and conducting training, meetings and “TOOL BOX” talks for all company and contractors staff.
- Inspection of safety precaution of signboard and safety tape to avoid accident. Always remember the company’s policy, which is to target zero accident.
- Monitor all workers’ to ensure compliance of proper personal protective equipment. To ensure all necessary safety precaution in job site.
- Inspect the heavy equipment’s, Cranes, Loader, Shovel, Forklift and Bobcat.
- Monitoring the First Aid Clinic and Ambulance.
- Maintain a checklist for entrance of personals, equipment and vehicles to the job site to make sure that all personals are evacuated in case of emergency evacuation.
- Membership in Investigation Committee & preparation of incident and conclusion reports.
- Daily monitoring the workers at the job site area to ensure the supervisors / foremen / charge hands that safety talk (T.B.T) conducted before they start the work at least 5 to 15 minutes.
- Daily monitoring for the workers at the job site area to ensure that they maintain their respective area tidy and clean (Housekeeping) for at least 10 to 20 minutes before knock-off time in every day.
- Daily checklist monitoring for the cranes as per company procedure to avoid accidents during operation and secure that the surroundings well cordoned and barricaded thereof.
- Check and inspect power, electrical, & mechanical tools etc. used by the workers at the job site to secure in good conditions to avoid any untoward accident happen while commencing their job.
- Check the permits and monitor and check that all excavations particularly more than 1.25 deep has been properly cordoned, barricaded or barriers installed for the protection of the personnel and vehicles.
- Daily monitor for the workers to ensure that they are comply the safety rules and regulation and make a violation report of the violator for dispensatory action as per company procedure and command of responsibility.
- Monitor the workers in cable pulling to ensure that they tie-off their lanyard to the life line when they are performing their job on high Elevation & Edges.
- Monitoring the electrical group while performing their job in remote instrument building and main control building.
- Monitoring the loop checking job of subcontractor.
- Attend the following refresher safety training arranged by client representative. (1. Safety Orientation and Induction, 2. Confined Space, 3. Working at Height, 4. Lock out / Tag out (LOTO), 5. Basic First Aid).
- Monitor all workers if they are wearing safety paraphernalia at job site, and put necessary safety precaution before starting any job.
- Make daily reports regarding safety in the job site and submitted it to the HSE Manager (Head office).
28th June 2012 to 1st Feb 2014
