Substation Design Engineer - ELectrical
EMCO limited
Total years of experience :12 years, 2 Months
reas of Expertise: •
Drawing Preparation.
• Key Single line Diagram’s. • AC and DC Distribution schemes. • Control and Relay Panel wiring Drawings. • Equipment wiring Drawings. • Cable Routing. • Switchyard protection single Line Drawings • Preparing Equipment layouts. • Substation Area Layouts • HV and MV Switchgear Room Layouts • Cable Trench Layouts • Indoor and outdoor area lighting layouts • Earthing layouts • Lightning Protection Layouts. • Protection and Control Design • Substation Protection System overview. • Developing Control Logic’s. • Have an idea on Relay settings. • Detail Earthing protection. • Direct Stroke Lightning Protection. • Preparing Cable Termination and Interconnection Reports. • Selection and Sizing of Equipment. • Current Transformer, Potential Transformer. • Battery and Battery Charger. • Conductor. • HT, LT and Control Cables • Lux level calculations for Indoor/Outdoor Lighting systems. • Power transformer, Distribution transformer & Lighting transformers • HV and MV switchboards • Main and Emergency Lighting distribution boards • UPS system, DC system, Batteries • Station Area Earthing, Cable trays • Diesel Generator set. • Harmonic Filter • Automation • SAS Communication Connectivity Drawing preparation. • Have an idea on system graphics and its remote operations. • System Configuration. • IED selection. • Preparing I/O list for SCADA from all Electrical Equipments.
• Have a command on all equipments used in SCADA. • Have an idea on IEC 61850 Protocol. • Analysis of Optical Time Domain Response. • Inspections and Drawing Approvals. • Electrical Equipment of Switchyard. • Have an idea of PLCC. • Tender Activities: • BOQ preparation from scratch & detail review of the bid document. • Actively involves in Pre bidding information collection and post bidding clarifications.
• Software’s known: • Drawing preparation : Auto Cad - 2014, E3 • Illumination Calculation : CG Lux, Dia Lux. • Had an Idea on Software : E Tap, Matlab, PCM 600Automation, E-Plan • General : Microsoft Word, Microsoft
Electrical Systems design Engineer- substation, fit out factories. Process Industries
Substation Design Engineering
Jawaharlal Nehru technological University, Kakinada-2007-2011/ Electrical and Electronics Engineering - 68.5% Intermediate Board of Andhra Pradesh 2005-2007/ Maths. physics, chemistry - 90.2%