Telecom suprintendent
CHEC
Total years of experience :16 years, 7 Months
Duties and Responsibilities:
Preparing Material technical submittal as per requirement of the project.
Preparing Shop drawings and Co ordination drawings.
Calculating Project quantities and scheduling duration of projects.
All Calculations pretending sub supplier for major telecommunication equipment as well as
associate drawings & designs.
Reviewing Contract drawings issued by client for interface and conflicts in the location of the
work.
Representing the discovered conflicts to the client and proposing solution to the client to
resolve any such issues, taking into consideration the overall requirement of the work set forth
in the contract.
Planning management and supervision of project development as per the client standards and
guidelines.
Management and planning all the technical aspects of the project including FOC installation,
splicing & termination, FDT installation, Access network equipment including OLT.
Calculation of Actual and forecast quantities of installation.
Supervision to ensure delivery of quantity in time.
Close co ordination with procurement department /client and supplier for approval and delivery
of required material.
Coordinating with different disciplines for the construction of Telecom infrastructure.
Attending technical and coordination meetings with clients for standards appliance and project
schedule.
Coordinating with Saudi Govt. regulatory authorities for work permits and standard compliance.
Working with planning department to update the project schedule and purpose change (if
required).
Responsible of final testing and installations and hand over to the customer.
PROJECT DESCRIPTION
As part of the ongoing development of the Mardumah District, the Royal Commission proposes
to construct the primary infrastructure for phase 2 of the district. A diagonal boulevard road
runs through the district and phase 2 is the portion north of this road. The area covered by
phase 2 is approximately 365 hectares and includes the following systems:
• Roads Network
• Storm Drainage
• Sanitary Waste Water (including lift stations)
• Potable Water
• Treated Sewage Effluent
• 13.8kV Medium Voltage Power
• Telecommunications
• Potable Water Transmission line from phase 1 through phase 2 area along TS-2.
• Treated Sewage Effluent Transmission line from phase 1 through area along TS-2.Rough
grading of the Site has previously been carried out under Contract 51 O-C41 and 510-C45 to
provide a level platform at level ranging from +7 meters to 15 meters
Duties and Responsibilities:
Following IFC packages for all telecommunication Works.
Preparing RFI for race ways (home runs) of all system.
Coordination with client PMT for race ways and any modifications in IFC.
Coordination with client PID for race ways inspection.
Preparing & Updating RFI, MOS, ITP, QCP, MIR’s, QVD Log Sheets and submitting to PMT.
Raising TQ & SQ for unknown technical issues on site these will be done before inspection with
PID.
Preparing Technical submittals for materials.
Issuing NCR for violation problem’s on site.
Making red line diagrams as per the site conditions for race ways and getting Approval of that
red line diagrams with PMT.
Coordination with VENDORS for the concern system, and explain about the system race ways for
installing devices.
Attending official meeting with VENDORS.
Attending meetings with CLIENT to discuses Quality of work.
Discussing about targets and progress with project manager.
Make sure of the materials for forehead project and utilizing manpower in a correct manner.
Involving in Termination and commissioning with the concern VENDOR.
Make sure of using approval materials.
Perfectly following client standards.
Inspection of cable continuity test.
Verify the Location of Duct banks according to given IFC drawing and laying of Conduits in U.G.
Preparing daily work reports.
Updating and monitoring punch list work, checking and commissioning works.
Responsible for the over-all implementation of Quality Control related telecommunication
works accordance with project specifications and Engineering Standards.
PROJECT DESCRIPTION
As part of the ongoing development of the Mardumah District, the Royal Commission proposes
to construct the primary infrastructure for phase 2 of the district. A diagonal boulevard road
runs through the district and phase 2 is the portion north of this road. The area covered by
phase 2 is approximately 365 hectares and includes the following systems:
• Roads Network
• Storm Drainage
• Sanitary Waste Water (including lift stations)
• Potable Water
• Treated Sewage Effluent
• 13.8kV Medium Voltage Power
• Telecommunications
• Potable Water Transmission line from phase 1 through phase 2 area along TS-2.
• Treated Sewage Effluent Transmission line from phase 1 through area along TS-2.Rough
grading of the Site has previously been carried out under Contract 51 O-C41 and 510-C45 to
provide a level platform at level ranging from +7 meters to 15 meters
Duties and Responsibilities:
Preparing Material technical submittal as per requirement of the project.
Preparing Shop drawings and Co ordination drawings.
Calculating Project quantities and scheduling duration of projects.
All Calculations pretending sub supplier for major telecommunication equipment as well as
associate drawings & designs.
Reviewing Contract drawings issued by client for interface and conflicts in the location of the
work.
Representing the discovered conflicts to the client and proposing solution to the client to
resolve any such issues, taking into consideration the overall requirement of the work set forth
in the contract.
Planning management and supervision of project development as per the client standards and
guidelines.
Management and planning all the technical aspects of the project
Calculation of Actual and forecast quantities of installation.
Supervision to ensure delivery of quantity in time.
Close co ordination with procurement department /client and supplier for approval and delivery
of required material.
Coordinating with different disciplines for the construction.
Attending technical and coordination meetings with clients for standards appliance and project
schedule.
Coordinating with Saudi Govt. regulatory authorities for work permits and standard compliance.
Working with planning department to update the project schedule and purpose change (if
required).
Responsible of final testing and installations and hand over to the customer.
PROJECT DESCRIPTION:
The power output capability of a given gas turbine plant is largely limited by the mass flow of air
that can be delivered at a particular ambient temperature to the combustion and turbine
sections. This is a function of the ambient temperature and humidity of the air. Many gas
turbines are equipped with systems designed to add water vapor or cool the air going into the
inlet of the compressor, or simply peak fire the turbine. Other systems inject large amounts of
steam or liquid water between the compressor discharge and combustion sections of the
machine, but these have not seen widespread adoption mainly due to the combination of high
costs for water and increased turbine maintenance requirements. These systems also
negatively affect the unit efficiency (heat rate) as energy that is required to vaporize the water is
not recovered. These systems are useful but provide only a small, incremental increase in
power.
The Turbo PHASE compressed air smarter peaking power system overcomes these
disadvantages by (1) avoiding the use of water or steam and (2) providing additional
compressed air via an arrangement that is typically much more efficient than and as clean as the
gas turbine itself. This results in continuous smarter peaking power capability of up to 10-20%
of the unit’s ISO rating and heat rate improvements of up to 7%-depending on the model of gas
turbine. The system is compatible with existing inlet fogging and duct burner systems and can
be applied to virtually any large gas turbine in simple cycle, combined cycle configurations.
Duties and Responsibilities:
Preparing Material technical submittal as per requirement of the project.
Preparing Shop drawings and Co ordination drawings.
Calculating Project quantities and scheduling duration of projects.
All Calculations pretending sub supplier for major electrical & telecommunication equipment as
well as associate drawings & designs.
Reviewing Contract drawings issued by client for interface and conflicts in the location of the
work.
Representing the discovered conflicts to the client and proposing solution to the client to
resolve any such issues, taking into consideration the overall requirement of the work set forth
in the contract.
Planning management and supervision of project development as per the client standards and
guidelines.
Management and planning all the technical aspects of the project including FOC installation,
splicing & termination, FDT installation, Access network equipment including OLT, IPTV system,
Building system.
Calculation of Actual and forecast quantities of installation.
Supervision to ensure delivery of quantity in time.
Close co ordination with procurement department /client and supplier for approval and delivery
of required material.
Coordinating with different disciplines for the construction of Telecom infrastructure.
Attending technical and coordination meetings with clients for standards appliance and project
schedule.
Coordinating with Saudi Govt. regulatory authorities for work permits and standard compliance.
Working with planning department to update the project schedule and purpose change (if
required).
Responsible of final testing and installations and hand over to the customer.
PROJECT DESCRIPTION
Royal Cornmission intends to undertake constructions of 5 school in jalmudha Al-JUBAIL.
The Work to be accomplished under this Contract consists procurement, supply,
installation, and construction of the schools. Site works include cut, filling, and grading
earthworks for site preparation, internal roads, sidewalks, road signs and marker, running
tracks, storm water drainage system, sanitary wastewater system, potable water and fire
water distribution system, electric power, street and wall mounted lighting system,
telecommunications network, construction of buildings.
Duties and Responsibilities:
Controlling Quality on site & Project documents.
Reviewing and Approval of ITP, MST, MSD, RFI, HPR of various Disciplines.
Issuing of NCR for violation of Quality.
Preparation of QVD of project.
Maintaining QVD logs.
Conducting Quality Talks.
Coordinating with different disciplines with an effective Quality Control Plan.
Attending Progress Meetings with Client to discuss Quality Control methods / issues.
Conducting SAT & FAT Tests.
3rd Party inspection Co ordination.
Preparation of RED LINE Drawings & MOC- Up’s.
Witnessing Testing & Commissioning Activities.
PROJECT DESCRIPTION
Royal Cornmission intends to undertake improvements to existing 36 schools in jalmudha
JUBAIL. The Work to be accomplished under this Contract consists procurement, supply,
installation, and construction of the improvements to existing schools. Site works include
cut, filling, and grading earthworks for site preparation, internal roads, sidewalks, road signs
and marker, running tracks, storm water drainage system, sanitary wastewater system,
potable water and fire water distribution system, electric power, street and wall mounted
lighting system, telecommunications network.
Duties and Responsibilities:
Following IFC packages for all Electrical & telecommunication Works.
Preparing RFI for race ways (home runs) of all system.
Coordination with client PMT for race ways and any modifications in IFC.
Coordination with client PID for race ways inspection.
Preparing & Updating RFI, MOS, ITP, QCP, MIR’s, QVD Log Sheets and submitting to PMT.
Raising TQ & SQ for unknown technical issues on site these will be done before inspection with
PID.
Preparing Technical submittals for materials.
Issuing NCR for violation problem’s on site.
Making red line diagrams as per the site conditions for race ways and getting Approval of that
red line diagrams with PMT.
Coordination with VENDORS for the concern system, and explain about the system race ways for
installing devices.
Attending official meeting with VENDORS.
Attending meetings with CLIENT to discuses Quality of work.
Discussing about targets and progress with project manager.
Make sure of the materials for forehead project and utilizing manpower in a correct manner.
Involving in Termination and commissioning with the concern VENDOR.
Make sure of using approval materials.
Perfectly following client standards.
Inspection of cable insulation Meggaring/continuity test.
Erection installation of control panel, transformer, over hauling repair and testing of all kind of
cables Meggaring, Insulation resistance and testing breakers.
Line Checking and Meggaring of Low Voltage Power and Control Cables.
Responsible for the over-all implementation of Quality Control related electrical works
accordance with project specifications and Engineering Standards.
PROJECT DESCRIPTION
Royal Cornmission intends to undertake improvements to existing 36 schools in jalmudha
JUBAIL. The Work to be accomplished under this Contract consists procurement, supply,
installation, and construction of the improvements to existing schools. Site works include
cut, filling, and grading earthworks for site preparation, internal roads, sidewalks, road signs
and marker, running tracks, storm water drainage system, sanitary wastewater system,
potable water and fire water distribution system, electric power, street and wall mounted
lighting system, telecommunications network.
Duties and Responsibilities:
Monitoring the production line of 2.5 KVA Bulk Inverter, 25 KVA Static Inverter, 600 V Precooling
Battery Charger.
Improve manufacturing efficiency by analysing and planning work flow, space requirements and
equipment layout
Remove waste from the processes
Keep up with current and developing engineering trends
Write reports and present progress at project meetings and to clients
Lead and/or support technicians and trainee engineers
Train people within own work group
Supervise sub-contractors
Diploma in Electrical & Electronics Engineering. Award wining QC Manager by Royal Commission Jubail / Yanbu.