Michael Rapanut

As a maintenance engineer I ensure that all my equipments are in good condition & functioning properly.I assure to cater the plant necessities & follow the standard & specification in the organization. I strictly follow the HSE (Health & Safety procedures) imposed by our HSE team. I daily attended meetings for our production & especially maintenance concerns. I manage my people to have efficient work output & to have efficient work place environment as well.

*Conduct early commissioning activities prior for start-up in static and rotating equipment’s. (Pumps, compressor, heat exchanger, vessels, tanks, drums, columns & etc.)
*Conduct passivation testing in centrifugal pumps prior for start - up.
*Read-through static & rotating equipment check list prior for commissioning
*Line checking of piping’s in line with utility lines (Nitrogen, plant air, demineralized water, steam and hot washed water)
*Pressurizing the lines and conduct leak testing in different systems. (Plant air, Nitrogen system, potable water, etc.)
*Conduct Pump alignment using Traditional Alignment & Laser Alignment
*Preparing daily activity report.

*Responsible for the start- up, operation and shutdown of Gas Turbine Power Plant, in accordance with company work instruction.
*Monitors operating parameters of Gas Turbine Power Plant
*Carry out regular plant routines and highlight any discrepancies in accordance with company work instruction.
*Inform and record in logbook all activities, observations, instructions received, plans and programs relevant to plant operation.
*Performs weekly change- over of equipment from stand by to service in coordination with the duty control room operator.
*Checks actual operating parameters of running equipment to ensure that all are within control limit.
*Performs test running of pumps, motors and other equipment for preventive maintenance test works.
*Maintains and check-up lubrications of equipment and ensure that power plant equipment and auxiliaries are in good and efficient working conditions
*Performs isolation and de-isolation works for major equipment, auxiliaries and other system prior to repair for preventive maintenance.
*Carry out minor repairs and servicing of auxiliaries such as filters and strainers.
*Carry out housekeeping within area of responsibility.

*Conduct Fit-Up Inspection and Visual Inspection during/after welding.
*Line checking of pipes actual design, position, nature of welding and installation including revision.
*Make quality control inspection report for QC documentation and issue suitable documents according to non-conformance procedures.
*Visual inspection, checking and evaluating of final welding job, i.e. appearance, under cut, irregular cracks, pin hole, arc strike and other insufficient welding reinforcement as per ASME Standard.
*Witnessed Hydro-Test and Pneumatic Test prior for restoration
*Conduct monitoring of Test Packages prior for testing, i.e. Hydro Test; Pneumatic Test (Documentation)
*Material receiving Inspection and Documentation
*Develops and Implements method of quality control procedure
*Inspection in place and deliver materials on site for conformance with the requirement of the contract.
*Conduct final inspection together with client and owner representative prior for final acceptance and turn over.
*Conduct inspection for rotating and static equipment.
*For rotating equipment, we conduct inspection by checking the centering, elevation, levelness, and alignment of motor to pump, coupling gap, and pipe stress. Be sure that all must be comply for the required tolerance.
*For static equipment, horizontal or vertical equipment, we conduct inspection by checking the plumpness, elevation, levelness and orientation of equipment.
*Inspection of equipment preservation and prevention of all rotating and static equipment at site and ensure the integrity of the equipment prior to turn over period.
*Conduct serration inspection prior to bolt tightening
*Conduct inspection of bolt tightening with require torque value.